I have very small hsbWall details*

Issue:

My Details in the Stickframe seem very small.
When using the Stickframe Empty for the first time you might get a funny looking Detail in the H1-H2-H3-H4-T1-T2-E, when you use the command ‘’Update details in DWG’’.


Cause:

The cause of this is because the hsbSettings are set to INCH.


Solution:

  • Once you have set it back to ‘’mm’’ don’t forget to ‘’Update details in DWG’’ again.
  • When you do this you will get a few messages.
  • Select OK in both Dialog boxes.


  • This is the result you should have, a correct looking Detail.







Feedback and Knowledge Base