hsbwalls don't appear in Viewport properly 2

Issue:

Can’t see walls in the viewport, because the beams have been drawn in VP layer’s.  
layer issue.

Cause:

This happens when you have worked in paperspace and then go back to Model space the Layer is not automatically set back to Layer 0. This is a bug.  

Solution:

You need to check when working in model space you are always on Layer 0.
  • Run the command ‘’Rename’’ and rename them.




I’m using 00, because otherwise it will tell me I’m using double names.
Don’t forget to ‘’purge’’.

Issue:

Can’t see numbering in the viewport, because the beams have been drawn in $AUDIT-BAD layers.


Solution:

  •   Run the command ‘’Rename’’ and rename them.
I’m using 00, because otherwise it will tell me I’m using double names.
  • Don’t forget to ‘’purge’’.
  • Close the drawing and reopen it.






Feedback and Knowledge Base